This item can NOT be shipped to these states CA
RSS STRUCTURAL SCREW
Self-tapping screws with W-cut thread design, CEE thread, Zip-Tip, & Climatek coated
Sharp threads and points bite instantly
Small shank reduces splitting effect
Star drive round head with built-in shield
May be used as a lag screw replacement
#10 uses T24 bit
5/16" uses T30 bit & 3/8" uses T40 bit

RSS 5/16X5-1/8 IN. 50CT SCREW
SIZE:5/16 x 5-1/8"
QTY:50 GRK's RSSTM Rugged Structural Screw is made of specially hardened steel to provide you with high tensile, torque and shear strength. The sharp threads and points bite instantly into the material (including hardwood), reducing the splitting effect due to smaller shanks.

RSSTM screws which are 3"1/8 and longer have a six threaded CEE thread that enlarges the screw hole for the non-threaded portion of the fastener, allowing the wood to settle easily and increasing the screw's drawing strength. The CEE thread also reduces the likelihood of splitting the wood and the friction on the screw shank which can result in lowering the driving torque.

Our round head with built-in shield (washer type head) has no sharp edges such as on conventional lag screws. The added shoulder (nominal diameter) underneath the washer has the ability to center the RSSTM screw in pre-drilled hardware like hinges and connector plates. Short lengths of the RSSTM may also be used to install wire diamond mesh for stucco buildings.

The #30 Star Drive will deliver approximately 650 lbf of energy, eliminating the need to drill a pilot hole.

The RSSTM screw is the only lag screw replacement of its kind.
This product ships in approximately 1 days
This product is made in TW
This product can not be shipped to CA