6DP-KOUT 6 IN. CHIMNEY KIT
|
6DP-KTUP 6 IN. CHIMNEY KIT
|
8" Heat-Fab Black 90 Degree Corrugated Elbow, Nonadjustable
|
4" x 6-5/8" Selkirk Direct-Temp Appliance Adaptor, Vermont Castings, 4" High (for gas only)
|
The oval male end dimension is 5-3/8" x 9-3/4". The round female end accepts 8" diameter, 22-ga. stovepipe.
|
18" - 29", center to center, for venting to side.
|
29" - 50", center to center, for venting to top.
|
This item can NOT be shipped to these states CA
CHIMNEY SWEEP SQUARE WIRE BRUSH Wire chimney cleaning brush has stiff, - oil-tempered spring wire bristles Regular construction utilizes an open, - single spiral design with 6" of fill Plated shaft and 1/4" threading for easy - coupling with fiberglass rods or pull rings Individually packaged 16512 12 IN. SQUARE CHIMNEY BRUSH SIZE:12" |
HomeSaver Heat Shield Spacers With Screws And Anchors
|
This item can NOT be shipped to these states CA
TRANSITION DUCT Converts 3-1/4" x 10" duct to 7" round duct 412H 7 IN. ROUND TRANSITION PIPE DESC:Round |
0" - 18", center to center, for venting to rear offset.
|
8" Insul-Plug
|
6" DVL TELESCOPING BLACK STOVEPIPE
DVL double wall, telescoping pipe length
Use for a two-piece installation from stove -
to ceiling support box or finishing collar
No cutting required
SIZE= Adjustable length size
6DVL-68TA 40-68 TELESCOPE PIPE
SIZE:40" to 68"
FINISH:Black
|
This item can NOT be shipped to these states CA
KOSY WORLD VENT FREE GAS STOVE Charming wood stove styling Monterey gas stove Large open-face design offers flame enjoyment Large charred log set & dual yellow flame burner Dual fuel operation: Propane or Natural Gas Has 30,000 BTU output - heats area 1,250 sq.ft. Thermostatic heat control No electricity required - electronic ignition Dimensions: 14.37"L x 31.93"W x 28.27"H GSD2846 MONTEREY DF GAS STOVE FINISH:Black |
DURAPLUS WALL THIMBLE
Adjusts from minimum of 4-3/4" to a maximum-
of 7-3/4" wall thickness, fits between -
standard wall studs
Install with DuraPlus chimney pipe horizontally-
through the wall and extend minimum of 2" into-
the room beyond the interior wall
6DP-WT 6 IN. WALL THIMBLE
SIZE:6"
FINISH:Black
|
The Ultra-Temp Chimney System is a rugged chimney designed for maximum safety and performance!
Ultra-Temp includes a variety of components to meet every installation requirement. These components may be combined in a wide variety of ways to solve almos |
SuperPro by Selkirk has inner and outer walls of 304-alloy stainless steel. The mineral wool insulation is formulated to reduce the likelihood of corrosion.
Components, such as flashings, have a coating which has twice the corrosion resistance of galv |
7/12-13/12 SQUARE CEILING SUPPORT BOX
DuraPlus all-fuel - use with flat, vaulted or -
cathedral ceilings
24" tall support box
For 7/12-13/12 ceiling pitch
Supports up to 35 ft. of DuraPlus Chimney
Starter section built in
8DP-CS24 8 IN. SQ SUPPORT BOX
SIZE:8" - 24" Tall
FINISH:Painted Black
|
The components twist-lock together for a quick, secure, fastenerfree installation. DuraVent Direct Vent Pro is the most recommended system in the industry.
|
Type HT chimney pipe special augured in mineral wool insulation filling the space between stainless steel walls is only 1 inch thick, yet provides 17 times the insulating valve of brick. This optimum density of insulation stops expansion noises and resist
s and contains surges of heat. This allows the system to be enclosed with only 2 inch clearance to combustibles. The "solid pack" density comprises about 85 percent air. The mixture of extremely fine fibers trap this air in the pores of the insulation and
also blocks radiation heat transfer. Tested to 2100 degrees F. UL listed.
6"ID - 8"OD
Lgth In=36
This item cannot be shipped to APO/FPO addresses. Please accept our apologies
|
DuraChimney II is an exceptional factory-built alternative to pre-fabricated masonry chimneys. DuraChimney II is a unitized, lightweight design which eliminates the need for field assembly of pipe sections, allowing for faster installation. DuraChimney II is designed to stay cool on the outside, to provide a hot draft on the inside and to provide a fire-safe design that protects both the chimney and the building. The double-wall, air-cooled design allows the chimney to expand both radially and lengthwise under high temperatures.
|
Twist-locks directly to the bottom section of SuperPro. A finishing band is needed. Compatible only with SuperPro Factory-Built Systems.
|
Used when the flue collar of a stove is a bit too big.
|
DURAPLUS ALL-FUEL CHIMNEY PIPE
Triple-wall, all-fuel pipe for use with wood -
stoves, fireplaces, furnaces, boilers & more
.018" galvanized steel outer wall, .018" -
aluminized steel intermediate liner and .016"-
430 stainless steel inner liner
Insulated layers of ceramic blanket plus -
ventilated air space - UL Listed- UL 103HT
Locks tightly w/precision twist-lock connection
6DP-24 DURAPLUS PIPE
SIZE:6" x 24"
|
DURABLACK SINGLE-WALL STOVE PIPE
Single-wall interior stove pipe for connecting -
wood stoves to manufactured chimney
Use for a single-wall connector pipe
Requires 18" clearance to combustibles
24-gauge steel construction
Lock-seamed - painted black
Subtract 1-1/4" from length measurement -
to calculate the installed length
8DBK-24 8X24 SGL WL STVE PIPE
SIZE:BxC= 8"x 24"
DIAMETER:A= 8-1/8"
|
The components twist-lock together for a quick, secure, fastenerfree installation. DuraVent Direct Vent Pro is the most recommended system in the industry.
|
Used to connect woodstove to entrance of chimney. Crimped end should be oriented toward the stove to allow for condensationand creosote to flow down inside the pipe.
BLACK
24 Gauge
Size In=6 x 48
This item cannot be shipped to APO/FPO addresses. Please accept our apologies
|
SuperPro by Selkirk has inner and outer walls of 304-alloy stainless steel. The mineral wool insulation is formulated to reduce the likelihood of corrosion.
Components, such as flashings, have a coating which has twice the corrosion resistance of galv |
6" DuraVent DuraPlus Galvanized Chimney, 9" Length
|
DVL DOUBLE-WALL BLACK 45 DEG. ELBOW
Offsets obstructions as need for connecting -
wood stove to manufactured chimney
Designed for installation w/minimum clearance -
to combustibles: 6" to walls, 8" from top of -
horizontal run to ceiling - not adjustable
.016" stainless steel inner wall with .018" -
galvanized outer wall, painted black
24-gauge steel construction - lock-seamed
6DVL-E45 6 IN. 45 DEGREE ELBOW
SIZE:For 6" Pipe
FINISH:Black
|
SNAP LOCK ADAPTER WITH TRIM
DuraBlack adapter snaps into the ceiling support
box or finishing collar & extends down to fit -
into stovepipe for a drip-free connection
Provides a strong mechanical connection
Works with DuraPlus & DuraPlus HTC installation-
and DuraTech ceiling support box
Includes trim
6DBK-ADSL SNAP LOCK ADAPTER
SIZE:6"
FINISH:Black
|
6" Selkirk DSP Double-Wall Increaser, 6" - 8"
|
|
|
|
|
Copyright © 1999-2021 BuilderDepot, Inc. Site Designed and Maintained by Inline Internet Systems, Inc. |