24V, 40psi Heavy Duty Water Pressure Pump - 4.3 GPM Flow rates up to 17 litres/min (4.5 US gallons/min), pressure switch control, capable of pressures up to 2.8bar (40psi)Ideal for cleaning leisure boats, fish boxes, anchor chains and dinghies. Includes strainer. Features:
Specifications:
|
Deck Wash Pump - 40psi/3.5GPM/12V
Self-priming diaphragm pump 12V Flow rates up to 13.5 litres/min (3.5 US gallons/min), pressure switch control, capable of pressures up to 2.8bar (40psi)Ideal for cleaning leisure boats, fish boxes, anchor chains and dinghies.All models include strainer, 'L' also includes a nozzle. Features:
Specifications:
|
12v Deck Wash Pump
Self-priming diaphragm pump 12v. Flow rates up to 13.5 litres/min (3.5 US gallons/min), pressure switch control, capable of pressures up to 2.8bar (40psi)Ideal for cleaning leisure boats, fish boxes, anchor chains and dinghies.All models include strainer, 'L' also includes a nozzle. Features:
|
Heavy Duty Deck Wash Pump
Self-priming diaphragm pump 12v. Flow rates up to 17 litres/min (4.3 US gallons/min), pressure switch control, capable of pressures up to 2.8bar (40psi)Ideal for cleaning leisure boats, fish boxes, anchor chains and dinghies. Includes strainer. Features:
Specifications:
|
Heavy Duty Deck Wash Pump
Self-priming diaphragm pump 12v. Flow rates up to 17 litres/min (4.3 US gallons/min), pressure switch control, capable of pressures up to 2.8bar (40psi)Ideal for cleaning leisure boats, fish boxes, anchor chains and dinghies. Model includes strainer and a nozzle. Features:
|
Portable RV Waste Pump
The Flojet 18555-000 DC portable waste pump is the ideal solution for emptying holding tanks on recreational vehicles and avoiding dump stations. The macerator section grinds waste down to a particle size of 1/8" maximum so it can easily be pumped through a garden hose (5/8" minimum). The pump section is self-priming, permitting the unit to be mounted above the tank in a convenient location. Empties most recirculating toilets in less than 2 minutes; empties a typical 30-gallon holding tank in less than 3 minutes.The 18555-series waste pump will macerate and pump all waste and tissue normally found in recreational vehicle waste systems. IT WILL NOT HANDLE HARD SOLID OBJECTS, SANITARY NAPKINS OR RAGS
|
Premium Quad Series Pumps
Features:
|
Quad DC Water System Pumps
Voltage:12 (Vdc) Flow Rate: 3.3 US Gallons/Min (12.5 Litres/Min) Pressure Switch Setting:15psi (1.1 bar) Cut In, 35psi (2.5 bar) Cut Out Amp Draw: 3.9 (amp) Port Type:1/2" Hose & 1/2" Thread included Bypass:Included
|
Quad DC Water System Pump - 35psi/3.3GPM/12V
Self-priming diaphragm pump with 12v DC electric motor. Flow rates up to 3.3 gpm, pressure switch control, capable of pressures up to 35 psi. Features:
Specifications:
|
Quiet Quad Water System Pump - 115VAC
Features:
Specifications:
|
Quiet Quad' Water System Pumps
Voltage: 12 (VDC) Flow Rate: 3.2 US Gallons/Min (12.1 Litres/Min) Pressure Switch Setting: 22psi (1.5 bar) Cut In, 35psi (2.4 bar) Cut Out Amp Draw: 3.9 (amp) Port Type: 1/2" Hose & 1/2" Thread included Bypass: Included |
RV Macerator Pump from Flojet
Designed to add flexibility to Holding Tank service. With the Flojet Waste Pump you can not only empty the black and grey water tanks at the conventional Dump Station, but also down a toilet, into your house sewer clean-out, septic tank or into a mobile waste wagon. The Flojet macerator pump will empty a typical 30-gallon holding tank in less than three minutes. The time increases somewhat as the distance pumped is increased beyond 25'. The pump will macerate and pump all waste and tissue normally found in RV waste systems. The same high quality Jabsco design found in boat stores worldwide. Put an end to handling and rinsing a dirty 3" sewer hose; instead use a cleaner, easier to handle garden hose. Now you can pump up hill, and around corners. The RV waste pump will simplify and improve your RV experience! Features:
Easy to Install Because it is self-priming, it may be located up to four feet above the tank liquid level. The intake port is designed to accept a 3" ID slip-on hose and the discharge port will accept a 1" ID hose. When installed, the macerator can be used to empty the holding tank into any convenient sewer receiver such as a sewer clean-out at your home. Applications
Impeller Release Feature After long periods of non-use, a stuck impeller can be easily broken loose with a screwdriver inserted in motor shaft slot. Simply turn shaft clockwise as shown. Specifications Pump: Self-Priming Flexible Impeller with Stainless Steel Wearplate Impeller: "Jabsco Nitrile" compound Macerator: Stainless Steel Cutter reduces particle size to 1/8" (3mm) maximum Seal: Lip Type Ports: Inlet RV model - 3" (76mm) hose Motor: Permanent Magnet Type, Fully Enclosed, with Stainless Steel Shaft Includes Impeller Protection Device that shuts-off pump after 20 seconds of run-dry Complies with USCG Regulation 183.410 & ISO 8846 MARINE for Ignition Protection Weight: 3.5lb (1.6 kg) Approx.
|
Strainer Cover for 1720, 1740, 46200 & 46400 Features:
|
Water Booster System - 115V
The Flojet 2840 Series Booster Systems are designed to provide a constant water pressure of 0 to 40 psi (0.7 to 2.7 bar) and a maximum flow rate of 4.5 gpm at 10 psi (0.7 bar). The pump is fully automatic, with built in inlet strainer, pressure switch and check valve, and supplies smooth flow from tricke to full flow. Typical uses include applications where available water pressure is very low, and fluctuates widely. Easy installation requires only that the water lines be connected, and the power cord plugged in. Features:
Kit Consists of: 115V Quad MPU, 4.5 GPM, SW 40, 0.77 gal capacity accumulator tank, plastic monting board, and pump inlet strainer
|
Water Booster System
The Flojet 2840 Series Booster Systems are designed to provide a constant water pressure of 0 to 40 psi (0.7 to 2.7 bar) and a maximum flow rate of 4.5 gpm at 10 psi (0.7 bar). The pump is fully automatic, with built in inlet strainer, pressure switch and check valve, and supplies smooth flow from tricke to full flow. Typical uses include applications where available water pressure is very low, and fluctuates widely. Easy installation requires only that the water lines be connected, and the power cord plugged in. Features:
Kit Consists of: 12V Quad MPU, 4.5 GPM, SW 40, 0.77 gal capacity accumulator tank, plastic monting board, and pump inlet strainer
|
Water Booster System - 40psi - 4.5GPM - 24V The Flojet 2840 Series Booster Systems are designed to provide a constant water pressure of 0 to 40 psi (0.7 to 2.7 bar) and a maximum flow rate of 4.5 gpm at 10 psi (0.7 bar). The pump is fully automatic, with built in inlet strainer, pressure switch and check valve, and supplies smooth flow from trickle to full flow. Typical uses include applications where available water pressure is very low, and fluctuates widely. Easy installation requires only that the water lines be connected, and the power cord plugged in. Features:
Includes: 24V Quad MPU, 4.5 GPM, SW 40, 0.77 gal capacity accumulator tank, plastic mounting board, and pump inlet strainer
|
|
|
|
|
Copyright © 1999-2021 BuilderDepot, Inc. Site Designed and Maintained by Inline Internet Systems, Inc. |